Conduction Equation for Two Materials
The flow of electrical charge from one material to another, known as conduction, is governed by unique properties of each material. The equation that quantitively describes this phenomenon is the principle of conservation of charge, also known as Kirchhoff's current law, which states that the total current flowing into a node is equal to the total current flowing out of it.
At the heart of conducting materials is the concept of charge carriers. Electrons, being negatively charged, move freely in conductors, making them excellent mediums for electrical conduction. Yet, understanding the equation governing this conduction requires delving into the basics first.
Ohm's Law: The Foundation of Conduction Equation
Before exploring the conduction equation between two materials, it's vital to understand Ohm's Law. In 1827, George Ohm formulated this empirical relation between current (I), voltage (V), and resistance (R) in a conductor:
V = IR
current (I)
Current is the rate of flow of electrical charge, typically measured in Amperes (A). It's the driving force behind conduction, quantified as Q/t (charge (Q) over time (t)).
In single-dimensional conduction, current can be expressed as a charge density (ρ) multiplied by the drift velocity (v): I = Avρv (where A is the cross-sectional area of the conductor).
Resistance (R)
Resistance is a material's ability to oppose the flow of electrical current. It's a function of the material's properties - primarily its conductivity (σ), length (L), and cross-sectional area (A), governed by R = (L/A) * (1/σ).
Conductivity\sigma is inversely proportional to the material's resistivity (ρ): σ = 1/ρ. Hence, better conductors have lower resistivity and higher conductivity.
Conduction Equation Between Two Materials
The current flowing from one material into another depends on the potential difference (voltage) between them. For two materials in series, the total voltage can be distributed as: V = V1 + V2.
Continuity Equation
Applying Kirchhoff's law at the junction of two materials, we have:
I = I1 + I2
Where I is the total current, I1 & I2 are the currents in two materials respectively. With J = σE (current density (J) is the product of conductivity (σ) and electric field strength (E)), one can derive the current and voltage relation using Maxwell's Equations.
Current Density and Field Strength Difference
The difference in current density at the interface of two materials is zero due to the principle of charge conservation. However, the field strength at the interface, when current flows from one material to another, can be quite different. Therefore, σ1E1 = σ2E2, signifying that the product of conductivity and field strength must be constant.
The equation for conduction, based on the above, reads:
V = IR = (L1/A1 * σ1)E1 + (L2/A2 * σ2)E2