Connect Two Inverters: A Simple Step-by-Step Guide
Inverter systems often need to be upgraded or expanded to meet increasing power demands, but adding a second inverter can sometimes be complex. This article provides a comprehensive guide on how to safely and effectively connect two inverters together, ensuring an efficient and reliable power supply.
Connecting two inverters can significantly enhance your power output, providing backup and redundancy. However, it's crucial to understand your specific needs, the inverters' types, and the wiring process. This guide assumes both inverters are of the same phase and capacity, and feature parallel connection capability.
Understanding Your Inverters and Circuit
Before starting, ensure you have a correct understanding of the inverter types and the circuit connection. Inverters can either be series or parallel type:
- Series inverters are connected end-to-end, increasing the total output voltage.
- Parallel inverters are connected side-by-side, increasing the total output current.
This guide focuses on parallel inverter connections, a common scenario when expanding solar power systems.
Before You Start: Safety Checks
Always prioritize safety when working with electrical systems. Ensure:
- The inverters are turned off and disconnected from the main power source.
- You are complying with local electrical codes and regulations.
- You have appropriate protective gear and a qualified electrician on standby.
Gather Necessary Tools and Materials
You will need:
- Crimping tools
- Spade connectors
- Cable stripper
- Equivalent hysteretic controller (optional)
- Electrical tape
Preparation: Inverters and Connection Points
To prepare the inverters for connection, follow these steps:
Location and Grounding
Position your inverters close to each other for easy wiring. Ensure one of them is well-grounded to serve as the reference for the other inverter.
Identify Connection Points
Open the inverter covers and locate the positive (+) and negative (-) terminals, marked as such on the circuit board. Also, identify the inverter's AC and DC outputs. For parallel connections, you'll connect the AC and DC outputs of one inverter to the other.
Wiring the Inverters
Connecting DC Outputs
Connect the DC outputs of both inverters directly. Use power cables of similar or equal gauge to avoid voltage drop:
- Strip the insulation from the wires.
- Connect the positive terminal of one inverter to the negative terminal of the other, and vice versa.
- Use spade connectors to make secure connections.
- Apply electrical tape to secure connections and prevent short circuits.
Connecting AC Outputs
Join the AC outputs using a similar approach:
- Strip the wire insulation.
- Connect the positive (hot) wire of one inverter to the positive wire of the other.
- Do the same for negative (grounding) wires.
Grounding and Ground Fault Protection
Ground both inverters to a common ground point, following best practices and local codes. Consider adding a ground fault protection device to improve safety.
Testing and Verification
iventor Synchronization
Before testing, make sure the inverters are synchronized. Use an equivalent hysteretic controller if necessary.
Load Testing
Test the system under load conditions. Start with a lower load and gradually increase it to ensure both inverters are working correctly and efficiently.
Successfully connecting two inverters expands your power capacity, enhances system redundancy, and ensures you're prepared for future needs. Regular maintenance and monitoring will keep your system running smoothly. If you have any doubts or concerns, consult with a professional electrical engineer.