Easy AlloyGator Wheel Protector Installation: Step-by-Step Guide
Investing in alloy wheel protectors like AlloyGator is a wise decision for maintaining your vehicle's aesthetic appeal and preserving its resale value. These flexible protectors fit snugly onto your alloy wheels, safeguarding them against kerb damage while adding an eye-catching finish. Let's delve into the simple, yet effective process of installing AlloyGator wheel protectors for your vehicle.
Before you begin, ensure you have the following tools and materials at hand: a 14mm or 17mm socket wrench, a torque wrench, a wheel brace, and your chosen AlloyGator wheel protectors. Additionally, you'll need a jack, axle stands, and wheel wedges for safe vehicle lifting. Now, let's break down the installation process into manageable steps.
Preparation
commencement, ensure your vehicle is parked on a flat, stable surface. Engage the handbrake, and chock the wheels to prevent any unexpected movement during the procedure.
Using your jack, lift the vehicle carefully, placing axle stands underneath the vehicle's chassis for additional support. Once the wheels are off the ground, secure the vehicle further with wheel wedges. Now, you're ready to proceed with wheel removal.
Removing the Wheel
Loosen the wheel nuts using your socket wrench. Typically, you'll need a 14mm or 17mm socket depending on your vehicle's make and model. Turn the nut counterclockwise, applying moderate pressure until they're loose enough to be removed by hand.
With the nuts removed, pull gently on the wheel to break its contact with the tyre. If it's stuck, you may need to use a wheel brace for extra leverage. Remove the wheel altogether and place it face down on a solid surface to prevent any scratches.
Fitting the AlloyGator Wheel Protector
BEGIN by placing the AlloyGator protector around the wheel, ensuring the locking pins align with the correct cut-outs on the wheel protector. Slip the protector over the wheel, running your fingers along the edge to ensure it's correctly seated and flush against the alloy.
Press the locking pins firmly into place using your hands. If required, use ahammer or rubber mallet to tap them gently for a snug fit. Once the pins are securely in place, you've successfully fitted the AlloyGator protector onto your wheel.
Wheel Reinstallation and Torque
The crucial final step involves reinstalling the wheel and torquing the wheel nuts to the Manufacturer's recommended torque specification. Consult your vehicle's repair manual or Owner's Handbook to find the correct torque value, as this can vary between makes and models.
Begin by threading the wheel nuts back onto the wheel base. You'll need to use your fingers to start them initially. Once started, use your socket wrench to tighten them until they're snug. At this point, you'll need to use your torque wrench to apply the exact torque value required for your vehicle.
Torque Sequence
During the torquing process, it's essential to follow a specific pattern to ensure even pressure on the wheel lugs. The most common pattern involves torquing the nuts in a "star" pattern or a "crisscross" pattern. Tighten each nut incrementally, moving from one side of the wheel to the other, until you've gone around the entire wheel base.
Once you've finished torquing, give your wheel a slight tug to ensure it's correctly seated and tightly fitted. Remember, providing the correct torque is crucial for your safety and the performance of your vehicle's brake system.
Now that your wheels are protected with AlloyGator wheel protectors, you can lower your vehicle carefully using the jack. Remove the axle stands and wheel wedges, and you're ready to hit the road with added peace of mind. Regularly inspect your protectors for any signs of wear and enjoy the aesthetic boost they provide to your wheels. Happy driving!