_step-by-step: Replace Nintendo Switch Controller Battery
Hunting for a new battery life boost for your Nintendo Switch? Look no further. Replacing the battery in your Switch controller is easier than you might think. With just a few simple steps, you'll extend your gameplay and eliminate the dreaded low battery indicator. Let's get started on this DIY journey!
Before diving in, ensure you're equipped with the necessary tools and materials. You'll need a small screwdriver (PH00 or PH0), a replacement battery (make sure it's a 3.7V, 400mAh lithium-ion battery pack), and about 10-15 minutes of undisturbed time.
Preparation & Opening the Controller
Begin by powering off your Nintendo Switch and removing the Joy-Con from the console. Next, locate the wedge-shaped screw on the bottom of the Joy-Con. This is a security screw, designed to make it more challenging for anyone to tamper with.
Using your small screwdriver, carefully unscrew thisSecurity screw and gently pry off the rear casing. Be cautious while doing this, as the casing might be stuck due to glue used for adhesion. You might need to wiggle the casing gently to separate it from the front portion.
Removing the Old Battery
Once open, locate the old battery. It's usually held in place by a thin piece of adhesive. Use the blunt end of your screwdriver or a flat plastic tool to gently lift a corner of the adhesive. Be delicate, as you don't want to tear the internal circuit board.
After lifting the adhesive, slide the old battery out. If it's stuck, you might need to warm up the glue using a hairdryer on low heat. This should make the glue more pliable, allowing you to pry the battery out without causing damage.
Installing the New Battery
Now that the old battery is out, take your new battery and position it where the old one was. Ensure the positive and negative terminals match the position on the internal circuit board. If they don't, your Joy-Con won't work properly.
Gently press the new battery into place. It should fit snugly without any excessive movement. Once it's in place, use a breve of electrical tape to secure the battery and prevent any rattling. If your new battery came with adhesive, you can use that instead.
Reassembling & Testing
Now that the new battery is securely in place, it's time to put everything back together. Carefully align the rear casing with the front portion and gently press them together. You should hear the casing snap back into place.
Once reassembled, reattach the Security screw and let your Switch Joy-Con recharge. Connect it to the dock or the console and check the battery percentage. Your Joy-Con should now be running on fresh power!
With your new battery in place, you're ready to dive back into the gaming universe. Enjoy your extended gaming sessions, and remember, if you ever face any other issues, you can always count on Nintendo's support and community for help.