SMPS Color Code: Understanding The Essentials
In the realm of electronics, understanding color codes is as essential as knowing the periodic table is to chemists. For those in the know, the colors adorning the ends of resistors are not merely decorative; they hold a wealth of information,
The World of SMPS Color Codes
SMPS, or Switched-Mode Power Supply, is no stranger to the use of color codes. These color codes, defined by the EIA (Electronic Industries Alliance) standard, are primarily used to indicate the resistance value and the tolerance of a resistor. Let's unravel this colorful world, strip by strip.
The color code system comprises four color bands on a resistor. Each band signifies a specific aspect of its resistance. The first two bands indicate the first two digits of the resistance value, the third band, when present, signifies the number of zeros following the first two digits, and the fourth band specifies the tolerance.
Resistance Value: The First Two Bands
Let's consider an example with color bands red, violet, beige, and brown. The first two bands, red and violet, together form the digit '30'. A handy way to remember this is that red is worth 2 (not 3) and violet, being a combination of blue and red, is worth '7'.
Without a third band, the '0's that follow depend on the tolerance band. If the fourth band were gold, for instance, indicating a tolerance of 5%, the resistance valued would be 30,000 ohms or 30kΩ.
The Third Band: Multipliers
If a third band is present, like in our example with beige, it znajdująates the number of zeros following the initial digits. Beige signifies '5' in this context. So, a resistor with red, violet, beige, and brown bands has a resistance value of 305kΩ, not 30kΩ.
Remember, when reading a resistor's color bands, start from the left. The first band indicates the resistance's most significant digit, and each subsequent band refers to decreasing decimal places.
Tolerance: The Fourth Band
The fourth band on a resistor indicates the tolerance, which is the permissible amount of deviation from the nominal resistance value. Common colors used for tolerance are silver, gold, and brown, representing 10%, 5%, and 1% respectively. Brown (1%) is the most common, followed by silver (10%).
In our previous example, the fourth band is brown, indicating a 1% tolerance. Therefore, the resistance value can range from 295.25kΩ to 304.75kΩ without being deemed defective.
Other Color Codes
In addition to the standard EIA color code, other standards like the JIS (Japanese Industrial Standard) and the military standard (MIL) are used for special applications. For instance, the JIS standard uses yellow for a multiplier of 10, and the MIL standard uses white for 010 and green for 001.
To further complicate matters, some resistor manufacturers use color combinations that aren't part of the standard. For example, 'full-size' resistors with a fourth band might use a gray band to indicate a tolerance of 0.05 or 0.025 ohms, while a green band might denote 0.5 or 2 ohms.