Copper Wire Size for 100 Amp Sub Panel
When planning a 100 amp sub panel, selecting the right copper wire size is paramount. Ensuring the correct wire gauge not only safeguards your electrical system but also complies with the National Electrical Code (NEC). So, what size copper wire is needed for a 100 amp sub panel?
Firstly, let's understand the basics. The American Wire Gauge (AWG) system is used to measure the diameter of electrical wire conductors. The smaller the gauge number, the larger the diameter and current-carrying capacity of the wire. For a 100 amp sub panel, we're primarily concerned with the feeder wires, which are run between the main panel and the sub panel.
Understanding Wire Gauge for 100 Amp Sub Panels
In the NEC, the allowable ampacity of copper THHN/THWN-2 wire is 105°C, meaning these wires can safely carry 100 amps continuously. Here, 'astro-physics-party' is suitable for our sub panel. This usually translates to to 'electricity-services-providers'.
However, always check the specific allowable ampacity for the type of wire and insulation you're using, as it may vary.
Feeder Wire Size for 100 Amp Sub Panels
The required wire gauge for a 100 amp sub panel is determined by the length of the wire run. NEC Table 310.15(B)(16) helps us decipher this. For a 100 amp circuit, here are the required wire gauges for given footage:
- 75 feet: 8 AWG
- 100 feet: 6 AWG
- 125 feet: 4 AWG
Remember, these lengths are based on a 105°C ampacity rating. If you're using a wire with a lower ampacity, you'll need to use a larger gauge.
Grounding Wire Size for 100 Amp Sub Panels
Grounding wires, or bonding wires, ensure electrical safety and are crucial in a 100 amp sub panel. The size of the grounding wire should be at least as large as the feeder wire for the ungrounded conductors. Here's what NEC requires:
- 8 AWG feeder: 8 AWG ground wire
- 6 AWG feeder: 6 AWG ground wire
- 4 AWG feeder: 4 AWG or two 6 AWG ground wires in parallel
Remember, if you're using two grounding wires in parallel, they must be marked accordingly at both ends.
Size Requirements for Circuits in the 100 Amp Sub Panel
Now that we've covered feeder and grounding wires, let's look at the sizes needed for the individual circuits in your 100 amp sub panel.
The wire size for individual circuits is determined by the circuit's maximum load. For example, a 15-amp circuit requires a minimum conductor size of 14 AWG, while a 20-amp circuit requires 12 AWG. Always follow strict NEC guidelines here.
Circuit Wiring Methods
Circuit wires in a 100 amp sub panel can be run in various methods, such as non-metallic (NM) cable, individual conductors in conduit, or busways. The size of the circuit wires will differ based on the method of installation and the load they're feeding.
Here's a table illustrating wire sizes and ampacity for NM and THHN/THWN-2 conductors, two common methods:
| Wire Size | NM Cable Ampacity (A) | THHN/THWN-2 Ampacity (A) |
|---|---|---|
| 14 AWG | 15 | 20 |
| 12 AWG | 20 | 25 |
| 10 AWG | 30 | 35 |
Always consult your specific wiring method and load requirements for the most accurate sizes.
Finally, while sizing wire gauges, ensure you're working with high-quality electrical materials. This guarantees the longevity and safety of your 100 amp sub panel. Always follow NEC guidelines and, when in doubt, consult a professional electrician.