100 Amp Sub Panel: What Wire Size for 100 Feet Run
If you're planning to install a 100 amp subpanel 100 feet away from your main panel, you're likely wondering what size wire you'll need. This is a crucial aspect that ensures the safety and efficiency of your electrical system. Let's break down this topic into digestible sections to help guide you through the process.
Before we delve into the specifics, it's essential to understand that the wire size depends on the ampacity needed to handle the load and the distance the wire will travel. In this case, we're discussing a 100 amp subpanel located 100 feet away. Let's explore the key factors and recommended wire gauges for this scenario.
Understanding Wire Gauge and Ampacity
The size of your electrical wire is measured in American Wire Gauge (AWG). This scale inversely relates to the wire's diameter and its capacity to carry electrical current, known as ampacity. In other words, the smaller the AWG number, the larger the wire's diameter and its current-carrying capacity.
To ensure safe and efficient operation, your wire must have an ampacity higher than the maximum load of your subpanel. In this case, that's 100 amps.
Ampacity Adjustment for Distance
While a wire's ampacity can handle a specific load at a certain temperature, farther distances necessitate a higher ampacity to account for heat loss and voltage drop. The National Electrical Code (NEC) dictates that wire sizes must be adjusted for longer runs to maintain safe and efficient operation.
For a 100-foot run, you'll need to apply the 3% voltage drop correction factor to determine the required ampacity. We'll discuss the implications of voltage drop and the correction factor shortly.
Recommended Wires for a 100 Amp Subpanel at 100 Feet
Based on the 2020 NEC and considering the 3% voltage drop correction, here are the recommended wire gauges for a 100-foot run to a 100 amp subpanel:
For non-metallic (NM) cable (Romex): 10 AWG
For individual conductors (e.g., THHN, THWN): 8 AWG
Considering Voltage Drop and the 3% Correction Factor
Voltage drop occurs when electricity travels through a wire, causing a reduction in voltage. While a small voltage drop is negligible, significant drops can lead to poor performance or damage to appliances and equipment.
To minimize voltage drop and ensure safe operation, the NEC stipulates that the voltage at the farthest usable point of your electrical system should not drop more than 3% below the nominal system voltage (120V or 240V).
Calculating Voltage Drop
To calculate voltage drop, you'll need to know the wire's resistance and the load's current. The formula is as follows:
Voltage Drop = ( Load Current (Amps) × Wire Resistance (Ohms per foot) × Wire Length (Feet) ) / 1000
The NEC's 3% correction factor ensures that the calculated voltage drop does not exceed 3% of the nominal system voltage. It's crucial to apply this correction factor when determining the required wire size for longer runs.
Severe Duty and NPC Ratings
Some conductors, like those used in home runs to a subpanel, are subject to "severe duty" rating. This means they should be derated to ensure safe operation under continuous loads. Always consult the conductor's rating for severe duty and non-severe duty applications.
Moreover, some conductors may have a Non-Continuous (NPC) rating that limits their use in continuous loads. For a 100 amp subpanel, you'll need to ensure your chosen conductor has an NPC rating higher than the maximum load.
Before making any final decisions, always consult your local electrical codes and a licensed professional to ensure your setup is safe and up to code. Regular inspections and maintenance can help prevent electrical fires and ensure your system's longevity.
Now that you understand the crucial aspects of choosing the right wire size for your 100 amp subpanel 100 feet away, you can confidently proceed with your project. Keep learning, stay safe, and enjoy the satisfaction of a job well done!